سال انتشار: ۱۳۹۰

محل انتشار: نوزدهمین همایش سالانه مهندسی مکانیک

تعداد صفحات: ۴

نویسنده(ها):

Hamed Ziaeipoor – Department of Mechanical Engineering, Isfahan University of Technology
Hasan Moosavi – Department of Mechanical Engineering, Isfahan University of Technology
Mohsen Safavi – Department of Mechanical Engineering, Isfahan University of Technology

چکیده:

An numerical investigation on the control of process parameters for the hydromechanical deep drawing with special attention to control of the blank holder force (BHF) is carried out. Sheet material St14 (Draw Quality Steel) of thickness 1 mm was used for this study. The effect of the counter pressure in the hydromechanical deep drawing process is investigated in combination with different constant levels of the BHF. An attempt to improve partial quality by control of the packing effect between the blank and draw die by varying the blank holder force according to the punch force have been explored. For the fracture prediction in this paper the forming limit diagram (FLD) Will be used. The results showed that rupturing and wrinkling controlled by using variable blank holder force based on punch force