سال انتشار: ۱۳۸۹

محل انتشار: دومین کنفرانس بین المللی الکترونیک قدرت و سیستم های درایو

تعداد صفحات: ۷

نویسنده(ها):

milad Basirifar – Electrical Engineering Dept. Iran University of Science and Technology Tehran, Iran
abbas Shoulaie – Electrical Engineering Dept. Iran University of Science and Technology Tehran, Iran

چکیده:

A cycloconverter is a power electronic converter which produces adjustable voltage adjustable frequency AC voltage from a constant voltage constant frequency AC source without any DC link. Cycloconverters produce significant harmonics and inter-harmonics in their output voltages. However harmonic behavior of cycloconverters widely depends on their pulse number, structure and switching strategy. Cycloconverter output voltage sub-harmonics, i.e. interharmonics with frequencies lower than fundamental frequency, greatly influence its performance and limit its maximum achievable output frequency. Several control strategies have been developed in years for reducing subharmonics and increasing cycloconverter performance quality. In this paper, two main control systems, i.e. cosine wave modulation and cosine wave modulation with voltage integral feedback are compared. Simulation results using MATLAB software are used to evaluate the analysis and signal THDs and harmonic components are calculated for further comparison. Experimental results obtained from a 6-pulse cycloconverter which was built in laboratory are used to evaluate the analysis.