سال انتشار: ۱۳۹۰
محل انتشار: چهاردهمین کنفرانس دانشجویی مهندسی برق ایران
تعداد صفحات: ۵
S Darabi – Department of Elec. Eng. K.N.Toosi University of Technology
Although many researchers use two-dimensional finite-element (2D-FEM) to analyze rotary motors, this paper presents that 2D-FEM is not always reliable. In this paper, the dynamic analysis of an 8/6 SRM based on FEM is performed. The SRM has been analyzed with Ansoft Maxwell. The results are shown that 2D-FEM is not acceptable compared to 3DFEM. The relative error in Mean value of moving torque ( ) is 17.17 %. 17% error in mean value of moving torque shows 2D-FEM’s weakness to analyze SRM. Although 2D-FEM has simple principles, the design of the motor using FEM requires a careful consideration of all flux paths. The advantage of 3DFEM compared to 2D-FEM is consideration of all flux paths.